Basic instructions:
Scan port Scan, Scan transfer trex software drives the control communication port, sometimes need to repeat twice or more times to Scan out of port, after but chose the port need to execute this command again until to open T software,
Dut X choice is control the port number, generally to 0 or 1, depending on the current main port numerical change,
Did show hard basic information (usually used to check the hard disk status, the firmware version)
Idps HDD high-level information (usually for viewing disk motor speed, firmware version date)
Soft Reset Reset disk, with no power function, just Reset the reading of the firmware,
With power to restart function Ireset hard disk hard reset (reset instruction),
Ipath input path "X" to specify the firmware, X parameters for the path of the detailed address, such as: "E: \ royl \ 11"
The Log x.t xt generates a text file named X parameter that, record operation details,
Showpaths view the current address of the path of the input and output information,
Options. After Fmtunit format the hard disk, enter 0 for internal format with P; 3 for internal without GP table formatting,
Fmt is
GP table format the hard disk shorthand instructions, generally used to format a small section of the test results, such as the dial is set good adaptation and Dan TPI, state before under evaluation of the performance of magnetic head start self-calibration,
Clrlog reset smart table, empty G table. Self-checking process,
Edit Edit drive model and capacity, first came after an execution model editor, and then the enter key is capacity after editing, such as 500 g 1 T 1.5 T
Edsn edit disk SN code
Vscon perform certain instructions must be assisted instruction before, the choice of TPI or grade, for example,
Recal used to knock a halt of hard disk to restart the test head, if the plate is matching circuit board. ROM is also wrote other compatible with family, execute this command after hard drive doesn't knock, turn a seek sound, that is caused by the firmware on disk, or knock proof do you have a head damage,
Hdtest X X using parameters specified SA area, speaking, reading and writing tests are executed the head of the judge head,
Ldata load ATA module (1640 board or above must be loaded the ATA module to recognize a plate to write modules)
Pickall extracted from orbital module, commonly used to deny plate under 1640 plate, external compatible ROM written later ready, then load the ATA module, and then use this command to extract, open C9 with winhex software module transcribing the original plate of TPI and Dan,
Clrpwd remove password,