You eldest brother elder sister, I do system with VB and crystal reports, the paper is a custom width: 11.10 cm, height: 14.00 cm, set the paper size and the actual paper size is the same, with a stylus printer set of EPSON1600K, print content not only print borders, to print more than 10 consecutive zhang will move down the whole 2 mm, I think no matter how much a print zhang, when the content of print 10 zhang set print move up 2 mm, so no matter how much to print all in the range of acceptable, are very urgent to solve today, scores can not give,

CodePudding user response:

Actual paper there is error, your single error is +/- 0.2 mm, quality is very good,
The custom paper will height to 13.98 cm not knot,

CodePudding user response:

The custom paper will height to 13.98 cm or there will be a whole complete down the situation

CodePudding user response:

Size of your statements do not account for 14.00 cm high,
Such as print content only 13.00 cm, margins calculated according to the paper size is 0.98 cm, automatic calculation by the program Settings before printing,

CodePudding user response:

Also not line, I doubt is the problem of EPSON1600K printer, online said EPSON printers there is this kind of circumstance, can add code to the crystal report each print 10 zhang set print the contents of the move up 2 mm, how to write code,

CodePudding user response:

Software only responsible for output, the output page logo,
If the printer paper feed, see if operating manual fine-tuning correction function,