Architecture:
10.1.250.11 Atlas
10.1.250.14 main library
10.1.250.32 from library
Main library followed the library has been configured with master-slave synchronization,
The atlas of configuration:
The user name # management interface
Admin - username=user
# management interface password
Admin - password=PWD
PWDS=buck: kOVJsquUepY=
# Atlas to monitor the work interface IP and port
The proxy - address=0.0.0.0:1234
# Atlas to monitor the management interface IP and port
Admin - address=0.0.0.0:2345
With navicat can even after launch the atlas, link below
Perform gain can be synchronized to the deletion from the library, no problem, but the use of command in 11 go up link is wrong the following
There is a problem is to use the set user name password also links and also links on navicat, screenshots are as follows:
Conclusion: there are three problems in doubt 1, set the buck why with navicat you can even use the command mode can't even (in 11 command can connect the main library and library),
2, why have work interface Settings and user commands even not
3, management interface Settings for commands and user why not
CodePudding user response:
Description, there are two navicat repeated is the second pictures sent you a wrong,Perform gain can be synchronized to the deletion from the library, no problem, but the use of command in 11 go up link error is as follows:
CodePudding user response:
Port - P P is capitalized