Ask how to solve the thank you

CodePudding user response:

Is installed after the restart appear this kind of circumstance?
The shaft is in flicker or not moving? Flicker of words should be a bit slow,
Is there any other information?
The virtual machine hardware setup posted a look?

CodePudding user response:

Shaft is fixed stationary reboot anyway is installed directly to the black screen above state

CodePudding user response:

When open the virtual machine is directly like this? Don't have any information?
VMware startup Settings, select the startup these don't appear?
It is very strange, set the startup see,

CodePudding user response:

The

refer to the original poster qq_36675830 response:

Ask how to solve the thank you

reference 1st floor cy309173854 response:

is installed after the restart appear this kind of circumstance?
The shaft is in flicker or not moving? Flicker of words should be a bit slow,
Is there any other information?
The virtual machine hardware setup posted a look?

Rung is stationary

CodePudding user response:

The

reference 3 floor cy309173854 response:

open when the virtual machine directly like this? Don't have any information?
VMware startup Settings, select the startup these don't appear?
It is very strange, set the startup see,

how to set ah, please give advice or comments

CodePudding user response:

The

reference 3 floor cy309173854 response:

open when the virtual machine directly like this? Don't have any information?
VMware startup Settings, select the startup these don't appear?
It is very strange, set the startup see,

Ann F2 F12 have no access to the Esc

CodePudding user response:

Is the point of you start the virtual machine, this will flash the interface, it soon passed, and then enter the system startup,,

CodePudding user response:

refer to 7th floor cy309173854 response:

point is you start the virtual machine, this will flash the interface, it soon passed, and then enter the system startup,,

dui

refer to 7th floor cy309173854 response:

point is you start the virtual machine, this will flash the interface, it soon passed, and then enter the system startup,,

refer to 7th floor cy309173854 response:

point is you start the virtual machine, this will flash the interface, it soon passed, and then enter the system startup,,

right is this kind of situation just now, I have put the delete again have to install a the installation is to use the custom installation of typical installation was the last time the last time did not appear the situation of the black screen is in good condition
But also thank you

CodePudding user response:

Card is explained in this interface does not have any reaction, only load the vmware preload drive, no loading centos guide,
Classic mode installation appear this problem, the initial guess, because of insufficient memory, default within your computer was unable to complete the basic start loading, or there may be other reasons,
According to the similar problems happened in the past, most because of the deployment centos need to load the content is too much, too little memory allocated, lead to directly give up load, stuck in the initial interface,

CodePudding user response:

Disk format chosen the wrong? Does not set the ext3/corruption?

CodePudding user response:

Remove the disk pack again, should be the problem of the disk

CodePudding user response:

How do you solve this problem is, please?