Qualcomm QCA9880 wireless card use ath10k driver, 5 GHZ AP mode cannot run-CodePudding

LS1012ARDB under development board for NXP, use LSDK1809 engineering, cfg80211 and mac80211 drivers in the kernel configuration, and qualcomm QCA9880 nic ath10k drive, run the compiled, sta mode is normal, connected to the 5 g router speed to 867 m, but 5 g AP mode only 20 MHZ bandwidth, speed is very low, demand is the bandwidth of 80 MHZ, the rate of 867 m, the hostapd Example in the configuration file reference https://wireless.wiki.kernel.org/en/users/Drivers/ath10k/configuration hostapd config to use ac VHT80 mode with 11 ath10k,
The following for the operation of the extracted hostapd start wireless, can answer, ChongXie!!!!!
Root @ TinyDistro:/tmp# iw list
Band 2:
Frequencies:
* 5180 MHz [36] (dBm) 30.0 (passive scanning, no IBSS)
* 5200 MHz [40] (dBm) 30.0 (passive scanning, no IBSS)
* 5220 MHz [44] (dBm) 30.0 (passive scanning, no IBSS)
* 5240 MHz [48] (dBm) 30.0 (passive scanning, no IBSS)
* 5260 MHz [52] (dBm) 30.0 (passive scanning, no IBSS, radar detection)
DFS state: usable (for 1158 SEC)
* 5280 MHz [56] (dBm) 30.0 (passive scanning, no IBSS, radar detection)
DFS state: usable (for 1158 SEC)
* 5300 MHz [60] (dBm) 30.0 (passive scanning, no IBSS, radar detection)
DFS state: usable (for 1158 SEC)
* 5320 MHz [64] (dBm) 30.0 (passive scanning, no IBSS, radar detection)
DFS state: usable (for 1158 SEC)
* 5500 MHz [100] (disabled)
* 5520 MHz [104] (disabled)
* 5540 MHz [108] (disabled)
* 5560 MHz [112] (disabled)
* 5580 MHz [116] (disabled)
* 5600 MHz [120] (disabled)
* 5620 MHz [124] (disabled)
* 5640 MHz [128] (disabled)
* 5660 MHz [132] (disabled)
* 5680 MHz [136] (disabled)
* 5700 MHz [140] (disabled)
* 5720 MHz [144] (dBm) 30.0 (passive scanning, no IBSS)
30.0 * 5745 MHz [149] (dBm)
30.0 * 5765 MHz [153] (dBm)
30.0 * 5785 MHz [157] (dBm)
* 5805 MHz [161] (dBm) 30.0 (passive scanning, no IBSS)
* 5825 MHz [165] (dBm) 30.0 (passive scanning, no IBSS)
* 5845 MHz [169] (dBm) 30.0 (passive scanning, no IBSS)

Root @ TinyDistro:/tmp# cat hostapd. Conf
Interface=wlan0
Ssid=PZ888999
Driver=nl80211
The channel=153
Hw_mode=a
Ht_capab=[HT40 +]
Ieee80211n=1
Ieee80211ac=1
Vht_oper_chwidth=1
Vht_oper_centr_freq_seg0_idx=159

Root @ TinyDistro:/tmp# hostapd./hostapd. Conf - dd
The random: Trying to read entropy from/dev/random
The Configuration file:./hostapd. Conf
Rfkill: initial event: independence idx=0 type=1 op=0 soft hard=0=0
Nl80211: Supported cipher 00 0 f - ac: 1
Nl80211: Supported cipher 00 0 f - ac: 5
Nl80211: Supported cipher 00 0 f - ac: 2
Nl80211: Supported cipher 00 0 f - ac: 4
Nl80211: Supported cipher 00 0 f - ac: 6
Nl80211: Using driver - -based off - channel TX
Nl80211: interface wlan0 in phy phy0
Nl80211: Set mode ifindex 3 iftype 3 (AP)
Nl80211: Failed to set interface to mode 3:3-16 (Device or resource busy)
Nl80211: Try mode change after setting interface down
Nl80211: Set mode ifindex 3 iftype 3 (AP)
Nl80211: Mode change succeeded while interface is down
IPv6: [1451.056761] ADDRCONF (NETDEV_UP) : wlan0: the link is not ready
Nl80211: Setup the AP (wlan0) - device_ap_sme=0 use_monitor=0
Nl80211: Subscribe to MGMT frames with AP handle 0 xaaaae78a95a0
Nl80211: Register frame type=0 xb0 (WLAN_FC_STYPE_AUTH) nl_handle=0 xaaaae78a95a0 match=
Nl80211: Register frame type=0 x0 (WLAN_FC_STYPE_ASSOC_REQ) nl_handle=0 xaaaae78a95a0 match=
Nl80211: Register frame type=0 x20 (WLAN_FC_STYPE_REASSOC_REQ) nl_handle=0 xaaaae78a95a0 match=
Nl80211: Register frame type=0 xa0 (WLAN_FC_STYPE_DISASSOC) nl_handle=0 xaaaae78a95a0 match=
Nl80211: Register frame type=0 xc0 (WLAN_FC_STYPE_DEAUTH) nl_handle=0 xaaaae78a95a0 match=
Nl80211: Register frame type=0 xd0 (WLAN_FC_STYPE_ACTION) nl_handle=0 xaaaae78a95a0 match=
Nl80211: Register frame type=0 x40 (WLAN_FC_STYPE_PROBE_REQ) nl_handle=0 xaaaae78a95a0 match=
Nl80211: Add own interface ifindex 3
Nl80211: if_indices [16] : 3
Phy: phy0
BSS count 1, BSSID mask 00:00:00:00:00:00 bits (0)
Nl80211: Regulatory information - country=00
Nl80211:2402-2472 @ 40 MHz 20 mBm
Nl80211:2457-2482 @ 20 MHz 20 mBm (no IR)
Nl80211:2474-2494 @ 20 MHz 20 mBm (no OFDM) (no IR)
@ 80 MHz 20 mBm nl80211:5170-5250 (no IR)
Nl80211:5250-5330 @ 80 MHz 20 mBm (DFS) (no IR)
Nl80211:5490-5730 @ 160 MHz 20 mBm (DFS) (no IR)
@ 80 MHz 20 mBm nl80211:5735-5835 (no IR)
Nl80211:57240-63720 @ 2160 MHz 0 mBm
Nl80211: Added 802.11 b mode -based on 802.11 g information
Allowed channel: chan mode=1=1 freq=2412 MHz max_tx_power=20 dBm
Allowed channel: chan mode=1=2 freq=2417 MHz max_tx_power=20 dBm
Allowed channel: chan mode=1=3 freq=2422 MHz max_tx_power=20 dBm
Allowed channel: chan mode=1=4 freq=2427 MHz max_tx_power=20 dBm
Allowed channel: chan mode=1=5 freq=2432 MHz max_tx_power=20 dBm
Allowed channel: chan mode=1=6 freq=2437 MHz max_tx_power=20 dBm
Allowed channel: chan mode=1=7 freq=2442 MHz max_tx_power=20 dBm
Allowed channel: chan mode=1=8 freq=2447 MHz max_tx_power=20 dBm
nullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnull