The tools needed for

Ch341a programmer ($20)
Method of use:

Programmer kit includes: programmer, cable, chip clip, transfer of

Programmer on two groups of jack, a total of 16, is a set of 25 chip insert, the programmer on only one side of the USB plug, 24 chips jack, another group is located in the compressive bar side
There is a thin plastic interval, through reverse programmer can see "BIOS SPI 25" and block "EEPROM 24 I2C" logo
Facing the programmer positive, the programmer USB plug downwards, programmer chip in the first column of the first 25 line hole position is line 1

Will dock chip clip link cable, the other end of the connecting plate, cable with a red line is the line 1, the corresponding adapter plate pile on the # 1

Adapter plate connected to the cable, will transfer board line 1 docking corresponding programmer chip 25 # 1

Red line along the cable check chip clip # 1

Huawei ct5000 rising male version BIOS firmware, device driver programming, the programming software
Data download address

Dial: link: https://pan.baidu.com/s/1p0lmZrWOTo9DxJ1EzvwC-g
The extracted code: j28j
Google dish: https://drive.google.com/drive/folders/1WD1Q8b9ZL87nHUP2ziWfzo5rCIqVSl71? Usp=sharing

Huawei ct5000 host
Locate the BIOS chip

Host on the back of the power supply socket with the words "12 v", the font is above the machine cover, base under way, pry boot lid off eight screws, remove the heat sink
Next to the BIOS chip position is located in the battery with marker pen point blue dots, should be a point when they leave, chip, a total of eight pins
Chip on the word "winbond 25 q32f" watch carefully
The BIOS chip four Angle one Angle has a small dot, line 1 is located in the Angle of the chip pins

Install programmer driver:
Click on "driver is very important to double click the" install, the default next next

Burn firmware
Open the "local tyrants gold programmer software", click "CH341A. Exe" programming software, the chip clip clip good corresponding to the chip of the # 1 # 1
Then will have good connection chip programming device plugged into the computer USB port, the software will be displayed at the lower "connected", otherwise please check whether chip clip clip ok
Click on the "test" button, the chip will be recognized, then click the "read" button and wait for a moment to read the complete
Save the read data to backup, click the "open" button, open "ct5000. Bin" file, click on the "automatic" button to start burning
Burn process to make a few minutes, burning into a state after the completion of the check again a few minutes, check will pop up after the completion of prompt box

Video tutorial
https://youtu.be/smudU1Qnjp8

You're done
Can use to write disc tool to openwrt firmware writing usb flash drive, and then put the usb flash drive huawei ct5000 host, the electricity powered up soft routing

Students have questions can leave a message or see my previous articles