Set, now not so much a huawei s5700 48 mouth of layer 3 switches, I divide 48 mouth four vlans, 12 for a vlan, each vlan as a switch is used, how to set op address under each vlan, and connect the superior route, for example 1 _12 mouth is vlan20, this 1-12 of IP for 192.168.1.1-192.168.1.254, specific how to set up, how do you write command? O great god told himself a small white one

CodePudding user response:

If there is no DHCP need not set, if you want to set need to see your topology

CodePudding user response:

Above is a household routing, even the computer directly to the below

CodePudding user response:

reference 1st floor Iforgetmyid response:

if there is no DHCP need not set, if you want to set need to see your topology

Household routing is above, below is the computer, the layer 3 switches connected computers

CodePudding user response:

Leave a mouth after the router if it is not stable can do port aggregation, EHT - trunk, and then write the default route is even the IP address of the router to you, what are you going to write a router inside back to routing
Then write a VLAN VLANIF, connect the computer directly below,
If you have any AC routing function have to way by debugging