Make three IP exchange or a number of segments each

CodePudding user response:

Is configured with ACL is applied to the corresponding interface is good!

CodePudding user response:

On a router ospf network is not declared to go directly

CodePudding user response:

Excuse me how configuration, detailed configuration commands

CodePudding user response:

refer to the second floor weixin_42466455 response:

directly on the router ospf network is not just declared it

Excuse me, how to configure

CodePudding user response:

LSW1 section that ar mouth screwdriver match gateway interface, the other two mouth directly with gateway

CodePudding user response:

Directly connected network, set up corresponding to the gateway on the PC must be Shared, don't need additional configuration,

CodePudding user response:

Different network segments with good vlan can use virtual vlanif interface,

CodePudding user response:

AR5 physical interface configuration IP with PC1, become PC1 gateway
Connected to the SW1 interface configuration interface, in a subinterface configuration 1.0 3.0 the IP address of the segment, into two net to the gateway,
Connect with SW3 physical interface configuration of the IP network segment, 2.0 to 2.0 segment gateway,
Then you can through the
On the same router, the interface connection segment without any routing protocol configuration can be data forwarding, this is called the local routing,

CodePudding user response:

The gateway 192.168.2.1 192.168.1.1, 192.168.3.1 set on the router, then add route on a router, and strategy with respect to OK

CodePudding user response:

Do the routing