How do the configuration, not visits

CodePudding user response:

This book in routing and switching

CodePudding user response:

This should be an introduction to experiment, a good reading

CodePudding user response:

Is to make the sw1 is vlan gateway both of the following three layers do when do trunk vlan switches connected port on the second floor and then open a spanning tree, three switches to go
I remember huawei simulator default routes open didn't open your open line

CodePudding user response:

Topic I configuration, on different vlans can't exchange, the layer 3 switching is to configure the static route

CodePudding user response:

reference shahe, 3/f, wu's reply:

is to make the sw1 is vlan gateway both of the following three layers do when do trunk vlan switches connected port on the second floor and then open three switches spanning tree, we have to do is
I remember huawei simulator default routes open didn't open your open line

Topic I configuration, on different vlans can't exchange, the layer 3 switching is to configure the static route

CodePudding user response:

reference 5 floor weixin_44964356 reply:

Quote: refer to the third floor of sha wu's reply:

is to make the sw1 is vlan gateway both of the following three layers do when do trunk vlan switches connected port on the second floor and then open three switches spanning tree, we have to do is
I remember huawei simulator default routes open didn't open your open line

On the topic I configuration, different VLAN cannot be Shared, the layer 3 switching is to configure the static route

Without three-tier configuration vlan configuration vlanip in open vlan routing functions