Which master what I see here is a list of questions has been restart
BOOT_OKEMMC
Relocation Offset is: 015 ff000
[AT] [MB] [start ub] [0]
2011.06-00000 - U - the Boot gf7ef1b0 - dirty (Jan 21 2017-00:13:43) MBOT - 1106.0.10.142 6731
MsIR_InitializeoUtopia...
The Function=SYSOpen, Line=814, current resource pri_shm content is: 0
The Function=SYSOpen, Line=833, [SYS INFO] OPEN INSTANCE...
Create the instance at 2 d7f7858 with private size of 108 bytes at 2 d7f78a0
[MIU INFO] MIU opencreate instance at 2 d7f7910 with private size of 84 bytes at 2 d7 F7958
Create the instance at 2 d7f79b0 with private size 48 bytes at 2 d7f79f8
Uboot by ats [2 d5ddf60 ~ 2 e900000], size=013220 a0
CPU: Curry#
Board: BD_MSZDEMO_2DDRV1_0_A
DRAM: 233 MiB
Now running in RAM - U - the Boot at: 2 de00000
EMMC: HS400 200 MHZ
EMMC 7.28 GB/E8FFF8h
In: serial
Out: serial
Err: serial
Net: No Ethernet found.
X55 xc6 MAC: 0 xc: 0:0:0 x87: x65 0:0 x63
Unknown command 'refreshcis - try' help '
[CPU INFO] CPU opencreate instance at 2 d807e90 with private size 44 bytes at 2 d8 07 ed8
CPUIoctl - MDrv_CMD_CPU_QueryClock
[UTOPIA INFO] close moduleNames (tu) : - xV4
[AT] [MBoot] [Driver Init] [0]
For Changelist: 00112233
=============set bootargs===============
Hit any key to stop autoboot: 0
Writing to MMC (0)... 128 blocks written: OK
128 blocks written: OK
The done
Writing to MMC (0)... 128 blocks written: OK
128 blocks written: OK
The done
Fore uup IRKey (0 XFF)
RST_GPIO... [do_bootcheck] [1118]... RST_GPIO_LEVEL=[1]
Check the USB port [0] :
(USB) usb_lowlevel_init + +
(USB) USB EHCI LIB VER: 2014.10.02
(USB) Port 0 is Enabled
(USB) TV_usb_init (UTMI Init) + +
(USB) UTMI f207500 Base 1
(USB) UHC f204800 Base 1
(USB) USBC f200e00 Base 1
(USB) BC f226e00 Base 1
(USB) config miu select [70] [F] [F]] [F]
(USB) enable miu lower bound address subtraction
(USB) TV_usb_init -
(USB) Usb_host_Init + +
(USB) Async base addr: 0 xe891100
(USB) x28 Reg 0:0 x1100 0 xe89
(USB) disable the run
2/USB Host Speed:
(USB) enable aynch
(USB) Usb_host_Init -
(USB) usb_lowlevel_init -
For devices with a scanning bus... 40 [USB] control1 Max:
(USB) interface [0] conf: 1 the value 8:
1 a USB Device (s) found
Scanning bus for storage devices... [USB] no_of_ep: 2
(USB) find bulk ep: 0
(USB) find bulk ep2:1
(USB) bulk Max packet size: ep (out) 0 x200, ep2 (in) 0 x200
(USB) bulk0 is out
Max lun: 0
A Storage Device (s) found
Partition 0 not valid on device 0 * * * *
* * Unable to use the usb's 0-0 draw for fatload * *
Reading/MstarUpgrade bin
* * Unable to read "/MstarUpgrade. Bin" from usb 1-0 * *
Partition 2 not valid on device 0 * * * *
* * Unable to use the usb 0-2 for fatload * *
Partition 3 not valid on device 0 * * * *
* * Unable to use the usb 3-0 for fatload * *
4 * * Partition not valid on device 0 * *
* * Unable to use the usb 0-4 for fatload * *
Partition 0 not valid on device 0 * * * *
* * Unable to use the usb's 0-0 draw for fatload * *
Reading/SbootUpgrade bin
* * Unable to read "/SbootUpgrade. Bin" from usb 1-0 * *
Partition 2 not valid on device 0 * * * *
* * Unable to use the usb 0-2 for fatload * *
Partition 3 not valid on device 0 * * * *
* * Unable to use the usb 3-0 for fatload * *
4 * * Partition not valid on device 0 * *
* * Unable to use the usb 0-4 for fatload * *
Partition 0 not valid on device 0 * * * *
* * Unable to use the usb's 0-0 draw for fatload * *
Reading/MbootUpgrade bin
* * Unable to read "/MbootUpgrade. Bin" from usb 1-0 * *
Partition 2 not valid on device 0 * * * *
* * Unable to use the usb 0-2 for fatload * *
Partition 3 not valid on device 0 * * * *
* * Unable to use the usb 3-0 for fatload * *
4 * * Partition not valid on device 0 * *
* * Unable to use the usb 0-4 for fatload * *
Partition 0 not valid on device 0 * * * *
* * Unable to use the usb's 0-0 draw for fatload * *
Reading/UrsaUpgrade bin
* * Unable to read "/UrsaUpgrade. Bin" from usb 1-0 * *
Partition 2 not valid on device 0 * * * *
* * Unable to use the usb 0-2 for fatload * *
Partition 3 not valid on device 0 * * * *
* * Unable to use the usb 3-0 for fatload * *
4 * * Partition not valid on device 0 * *
* * Unable to use the usb 0-4 for fatload * *
Warn!!!!! No upgrade file in usb.
AC on
!!!!!!!!! [do_audiopreinit] Skip the Power Music!!!!!!
nullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnullnull
