Dear bosses, I double than a mechanical engineering research a newcomer, laboratory teachers give direction is: the pendulum linear screw pump processing (using ordinary numerical control machine rotor), design a set of tooling, and produce a set of software, after requirement is given on various parameters, can be determined, optimization of machining parameters and eventually completed finally,
And said, I am under foundation, undergraduate direction is the mechanical and electrical, 87 points, level 2 C language compilation, PLC, STM32 microcontroller is studied,
I want to ask is, do the numerical control system development, a embedded development, what steps should from what teaching material from the start? What are the journal articles can see? Thank you bosses!!!!!!