Broadband in the home, there are two interfaces, one attached to a wireless router; Another directly plugged into desktop computer, but computers can't get to the Internet, which under the great god give answer, thank you

CodePudding user response:

Plugged into a computer that thread in to the router, connect with computer

CodePudding user response:

Plugged into a computer that thread to router side, walk line too troublesome, is there a better way? thank you

CodePudding user response:

Try to answer the wrong please correct me, but you just put two wires respectively on the wireless router, if it can be shown on the Internet 2 thread is pass, don't look at the route to get to the IP, then near the computer on the thong, deserve to go up the computer just to get IP to try again,

CodePudding user response:

Normally this kind of computer needs through dial-up Internet access, direct is not on,
Basic translation

CodePudding user response:

To do a broadband with operators, indicate to do data on cat into computer above the hole, and then on the computer can go online with new account password dial-up,

CodePudding user response:

Take the router to the PC side, with network cable plugged into the router, and then from the router to connect to your computer, it is need to put the router in the original place, can consider to bridge the router

CodePudding user response:

May be operators to open lines of unicast, (1) your computer network to the wireless router, (2) on the operators routing to your wireless router static IP, (3) for your wireless router IP management (4) is normal, check the equipment DHCP (dynamic host configuration protocol)
This is also a way of unicast line crack operators