Home > other >  Home routers, simplify, welding at least one cable crystal plug, reduce belt steel needle socket num
Home routers, simplify, welding at least one cable crystal plug, reduce belt steel needle socket num

Time:10-12

8 needles with curved steel needle so socket, magnetic properties is very poor, is almost eight wireless transmitting antenna. The original design, is in the low frequency of s, high frequency reveal that rarely. For today's high-speed network equipment is not suitable for the high frequency mainboard.,, considering the compatibility to adopt, should try to reduce the number. Home routers to simplify, welding at least one cable crystal plug, reduce belt steel needle number, socket, such as the upstream router mouth "WAN" is directly lead to welding line, it is the light of the cat's mouth downstream "so" and "iTV" still is 8 curved needle.

Reduce electromagnetic interference, reduce loss of plug socket contact resistance and increase speed. Save power.

CodePudding user response:

The elder brothers don't stir, you this is to use inferior products?
reference
very poor electromagnetic properties

What is the concept? How bad? MB can run full? Full gigabit can run? Don't take it for granted,
In fact thousands of signs in the network is common? Also the welding... Has this kung fu with optical fiber line not line?

CodePudding user response:

Can save material, reduce. A little head and a 8 needle crystal mesh. Can be beneficial to the manufacturer. The router has a welding good do upstream connection cables, reduced the line contact resistance loss, beneficial to speed up.

CodePudding user response:

Can save the equipment factory had saved, I buy correlates of switches is not so much the needle,

CodePudding user response:

Some network is four needles, 8 needles than simplified... But not directly welding cable, reduce and crystal plug

CodePudding user response:

To be honest, lz alarmist... If radiofrequency radiation, more manufacturers will not produce.

CodePudding user response:

Hopes to keep a router manufacturer is mouth line includes gold finger output, the user's own welding line in the gold finger, band bundle in circuit board or plastic box, prevent pulled away.

CodePudding user response:

I welding, demolition of a mesh, welding cable, left to right: green, white, green, orange, white and orange,

CodePudding user response:

This question is too talented

CodePudding user response:

Now a 9 change cable welding, four downstream reticulum chose changed cable pull over the outside of the welding, and note that a demolition of 4 couplet net, not all damage, or as a whole will lose fixed intensity, on one side column a small plastic card circuit board.

CodePudding user response:

About 70 cm upstream wire welding, the downstream line welding about 2 meters.