As is shown above, two computers can be connected to the Internet, but apparently not visit each other, should excuse me how to get the computer to access to each other?

CodePudding user response:

You is how to set the routing parameters B and C, use IPCONFIG command to see what was the IP address of the D and E, if is the same network segment is check firewall Settings, or security policy, if not, you can refer to this, http://jingyan.baidu.com/article/642c9d34ff0fa7644a46f79a.html

CodePudding user response:

reference 1st floor laiang8283 response:

how routing parameters B and C are you setting, use IPCONFIG command to see what was the IP address of the D and E, if is the same network segment is check firewall Settings, or security policy, if not, you can refer to this, http://jingyan.baidu.com/article/642c9d34ff0fa7644a46f79a.html

how is the Internet access to each other

CodePudding user response:

reference 1st floor laiang8283 response:

how routing parameters B and C are you setting, use IPCONFIG command to see what was the IP address of the D and E, if is the same network segment is check firewall Settings, or security policy, if not, you can refer to this, http://jingyan.baidu.com/article/642c9d34ff0fa7644a46f79a.html

Is a IP is 192.168.31.1 192.168.41.1 two routers within the subnet mask is 24, so I don't know how to do,

CodePudding user response:

refer to the second floor enpterexpress response:

Quote: refer to 1st floor laiang8283 response:

You is how to set the routing parameters B and C, use IPCONFIG command to see what was the IP address of the D and E, if is the same network segment is check firewall Settings, or security policy, if not, you can refer to this, http://jingyan.baidu.com/article/642c9d34ff0fa7644a46f79a.html

how is the Internet access to each other?

Is to make the two routers under all computers in a network,

CodePudding user response:

If you want to get into the router's Settings interface, not can baidu, and then simple point method is to B and C as switches use
1. Set the B and C the router LAN port parameters, such as A router IP is 192.168.1.1, then B is set to 192.168.1.100 (only the fourth segment and the main router IP conflict and between 2-254), and C in the same way can be set to 192.168.1.200, then B and C of the DHCP server is disabled, restart the router
2. A routing of cable connect B and C of the LAN port, don't answer the WAN port