PCB back display device properties, don't display device number, this is what causes? How to modify the

CodePudding user response:

Look at the generated Gerber files may be an error in the layer

CodePudding user response:

Silk screen layer display Settings is not on, as shown in figure, the hide designator are removed, the comment of the hide is checked, the export gerber to check the top silk silk layer and bottom layer of the display is correct,,

CodePudding user response:

refer to the second floor qq_21851929 response:

screen printing layer display Settings is not on, as shown in figure, the hide designator are removed, the comment of the hide is checked, the export gerber to check the top silk silk layer and bottom layer of the display is correct,,

This is the setting of protel or something, use the PADS as didn't see this one

CodePudding user response:

reference 1st floor woshi_ziyu response:

see generated Gerber file is likely to be an error in the layer

Give check, really do not know where, or didn't check the right place

CodePudding user response:

I think that looking for baidu faster

CodePudding user response:

Is Altium designer, pads not like that,

CodePudding user response:

Gaber file has a problem, can look at the plate in cam350 file if there is a problem

CodePudding user response:

Obviously is silk screen layer problem, only need to go over your gerber, or can be placed in cam350 watch it again,

CodePudding user response:

You put a number on bonding pad!

CodePudding user response:

Manufacturers should be in early remind you,

CodePudding user response:

Don't you send board check?

CodePudding user response:

No fixed pattern

CodePudding user response:

Proofing go home match next time, you generally don't know, where it will help you check it again before proofing tell you, and proofing effect is quite good, I first board is playing over there, is more expensive than the other

CodePudding user response:

Gerber file set didn't choose device properties

CodePudding user response:

Suggest check issued by the board