I am a pure white, don't understand the
Equipment huawei s5720-32 p - ei - ac

Optical fiber line is applied for unicom line

The above to the IP, subnet mask, gateway
Client connected address and operators end connected

Do I need to plug cable line came in where? The following three computer cable plug directly into the mouth 1.2.3, but they may not understand each other ping between

If need to use 232 front-end ports usb 485 turns, the two lines access switches and computer, then use what the simulation setup software set the switch?

Settings, you should make at first sight, client and operator needs to be set in where?

CodePudding user response:

Line where it doesn't matter, the key is you plug hole to open the TRUNK of 1, 2, 3, and 1, 2, 3 mouth open the TRUNK, and then enable the DHCP service, gateway, subnet, DNS Settings is good, if not, enable the DHCP IP is manually each PC

CodePudding user response:

Lines should not be directly put on the layer 3 switches, you also need a device: firewall, router, can,

CodePudding user response:

Outside in line, to pick up a firewall or router, do address mapping,

Switch configuration is the console lines to connect the computer, super terminal or computer to download secureCRT, then write configuration commands, some switch configuration support website login,

CodePudding user response:

Remind you for the sake of safety period, best before the layer 3 switches and firewall, and even a brake device, that can be used but not directly!!!!!!

CodePudding user response:

To configure a router or a firewall, the need to get to the Internet network segment to do an address mapping, and then the following a layer 3 switches at layer 3 deployment of all network segment for each other or isolation,