Microcomputer relay protection tester boot steps:

Insert the microcomputer relay protection tester power cord AC220V power socket, check the wiring, after open computer relay protection tester power supply respectively, and the external computer power supply, a moment later will choose the way to launch into the interface, as follows:

1. Direct Run RelayStar without Restoring Disks.

2. Run RelayStar After Restoring Disks.

3. Only Start DOS For Checking System.

Option 1: direct start Windows operating system, and then enter the "of" the bartender software main interface,

Option 2: will automatically restore the Windows operating system into the work, this process takes about four minutes, then to choose the way to start after the completion of interface, pilot controlled power after the damage of this option is mainly used for the operating system to start Windows system, to restore the Windows operating system to the factory state, pay attention to the automatic recovery will not be lost before the user test report and other data, please users don't have to worry about, but often use this option is not recommended to avoid spending too much time,

Option 3: will enter a state of DOS, mainly used for the management personnel debugging use, if the user accidentally entered, please turn off the host power wait for a while and after restarting,

Want to choose way available 1.2.3 number keys or key choices, shall be selected within five seconds, otherwise the system will automatically enter the option 1,

Start Windows operating system will automatically enter the main interface of software function test, using the trackball mouse or external mouse the left key click the various function test module icon on the main interface, can undertake all kinds of test work,