New laptop, lenovo E470C skylake platform, now need to install an old software, software instructions said only support to Windows 7 32 bit, the results after put Windows 7, found the software installation package click no reaction after the operation, check the process, found that launched the NTVDM, meaning that the installation package is 16-bit program that starts, has accounted for 25% of the CPU is not installed interface, later other machines in a virtual machine, use the same installation disk installed Windows 7, the result can normal open the installation of the installation program, after the installation directory and registry as is written in the notebook, the software can be normal open, but the most important is that this program will take a series of external equipment, must be specified by USB2.0 interface, after installed the program comes with a USB device drivers, software doesn't work properly,
Have one master know how to make software normal use? is really the XHCI skylake platform and software of the USB drive does not match? This notebook BIOS is very simple, no adjustment about XHCI close option, which warrior for advice on below, thank you very much ,
Online and so on, is very urgent,

CodePudding user response:

This problem is not solved? Really can't find other old machine installation

CodePudding user response:

Problem solved, the method is in the other low installed on the machine, install monitoring registry and hard disk files at the same time, and then installed file copy to the new machine, manual write registry, is manual green,

CodePudding user response:

And be sure to manually register controls

CodePudding user response:

refer to the second floor samson669 response:

problem is solved, the method is in the other low installed on the machine, install monitoring registry and hard disk files at the same time, and then put the installed file copy to the new machine, manual write registry, is manual greening,

Thanks to feedback the solution!