USG6000 series, this is the gateway 1.1.1.2. After routing 2.2.2.1,
Under the static routing is the destination address is 2.2.2.1/24; The interface is the gateway interface; The next-hop 1.1.1.3, is the WAN port fixed IP routing,
Then 1.1.1.2 ping impassability 2.2.2.1,
O,

CodePudding user response:

Feeling is a mess, as you describe you have 1.1.1.2 above 2.2.2.1 routing, also you can go to the lightning "crowdsourcing" bill of lading for someone to give you processing, feel this platform is good, free platform for professional engineers give you handle, platform www.csleibei.com

CodePudding user response:

You draw a diagram to see, completely don't understand your description

CodePudding user response:

Then 192.168.0.1 ping impassability 192.168.1.1.
192.168.0.1 the static routes configured

CodePudding user response:

192.168.1.2 instead can ping 192.168.0.1

CodePudding user response:

Not ah, this ability to configure the static route

CodePudding user response:

Your router's gateway should be 192.168.0.0/24 section of the WAN port Settings 192.168.0.3 then PC3 connect LAN port address of the router R2 should be 192.168.1.1,

CodePudding user response:

Use pc3 ping the 192.168.0.
If can't, look it up in the routing table, is not this address

CodePudding user response:

Even if the r2 wan mouth with 192.168.0. X, also not line, I checked the information, general routing with NAT translation, only by routing LAN port, but it takes up 0. X IP network segment,

CodePudding user response:

This is according to the specific environment, network routers can do NAT, change routing patterns, can ping, but according to your specific business to differentiate, look at your topology, network access gateway in the firewall, network routers can do NAT, routing mode instead,