Home > other >  Axure
Axure

Time:05-09

1 open Axure8 (axure7). Default is the newly created project, find "dynamic panel" element, the diagram below:

2 drag components to the workspace, follow the instructions of the figure of any one place to the dynamic panel name: test panel

Three components, double-click on the dynamic panel state state1, double-click into state1 editor:


4 drag and drop an image element into the state1, double-click the picture ready to found and (red), so that the first state to edit,

5 below to edit the second state, pay attention to look at the picture, within the "summary" section in the lower right to find right state1 "replicated state", so that the inside of the element size, the position will not change, after the success of the replication to facilitate the interaction case, named state respectively: red, blue flag,
Then click on the blue flag state, will replace,



6 after completion of the above steps, start editing interactive cases, double click on the red flag pictures, interactive cases appeared as shown in the figure below, find: a mouse click, and double-click a use case editor panel,


7 choose components - & gt; Settings panel, and then select the "testing" as shown, and it is set to choose status to: blue flag, set animation effects at the same time,


8 after the completion of the flag state to edit, click ok, as shown in figure under the case1 email copy use cases, and paste it into blue flag state, and then according to the previous step operation, sets the blue flag click yes select status to: the red flag,



9 the F5 preview, and click on the image test results


This is I learned Axure reference steps, so I want to share with you, hope you can help to you,
New hands, so that's my share, please advice, if there is a better way or do not know the place to welcome in the comments section to teach and questions!