I just learn this don't know what was wrong with trouble great god help to see if you can provide the best solution!
There is a lot of resistance pin is the status of figure 2 is not connected to circuit, but instead I use manual wiring button on even after the error more don't know how to connect,,, beg the eldest brother

CodePudding user response:

Great god with me

CodePudding user response:

Great god!!!!!!!!!! Great god??????

CodePudding user response:

Figure 2 right the red box to delete can eliminate the error

CodePudding user response:

When you look at the 65 class of problems is Silkscreen over component pads (Clearance=10 mil), mean screen printing device of welding plate distance must be at least 10 mil spacing, if less than 10 mil would be an error, you clear your figure 2 shows the error: bonding pad of purple rings to yellow screen printing label, there is a distance between indicating the distance & lt; 10 mil, the solution is Silkscreen was found in the Rules to pad clearance, put down to allow clearance, Suggestions for the 1 mil, guarantee the printing is not bonding pad on the ,

Another 76 problem is the last picture in the bottom right hand corner of crimson ROOM frame defines the components only cloth in this box, beyond just an error, the solution 3 floor already said, delete ROOM frame can ,

Other problems can go to repair the correct according to the literal meaning to understand, don't understand copy words to search,

CodePudding user response:

While importing PCB from the schematic diagram, a red box, and click delete it

CodePudding user response:

3/f method should be able to solve it,

CodePudding user response:

Method can eliminate the error, 3/f, the red areas to delete the can,

CodePudding user response:

The lower right corner of the red deleted

CodePudding user response:

Screen printing and pad too close alarm, adjust the RULE