In large companies (172.20. 7.0.x.x) within the local area network (LAN), A points at the same time, access to the internal and external network IP (172.20.10.8) to A department, the IP binding in A department of A routing wan, points A child LAN (192.168.0. X) for the entire department A use, now A have two hosts need to be other departments (172.20. 7.0.x.x section) to access, but the router access between the less than, what method can be accessed bosses have excuse me?
Required only in A department of the routing and 2 need to be access to the host to configure, may not be on the core routing configuration, there are ways to yao, no ideas, bosses give some ideas, thank you.

CodePudding user response:

Route is what kind of A department, support writing ACL?

CodePudding user response:

Want to see this A routing is what brand, what type of, support which set,

CodePudding user response:

reference 1st floor QCJQTVB response:

routing is what kind of A department, support writing acls,

does not support writing ACL, but now need method, can buy to support the new device

CodePudding user response:

refer to the second floor Iforgetmyid response:

to see this A routing is what brand, what type of, what support setting,

ordinary household soho type, huawei support NAT, DDNS, VLAN, UPNP, equipment is not A problem can buy again, now need method, thank you,

CodePudding user response:

reference 1st floor QCJQTVB response:

routing is what kind of A department, support writing acls,

there is with soft routing can be realized, and that's A lot of idle computer

CodePudding user response:

So playing is not very good, this topology is not so good, take the address of a network to a routing when the WAN, why not put a 2 switching everyone directly with (172.20. 7.0.x.x), is not enough or the address?

CodePudding user response:

refer to 6th floor Nickdong09 response:

so playing is not very good ah, this topology is not very good, also bring a network address to a routing when the WAN, why not put a second floor directly exchange with everybody (172.20. 7.0.x.x), is not enough or the address?

is a little special reasons

CodePudding user response:

A department that routing to switch mode, while forbidding the DHCP, can't

CodePudding user response:

Either add static routes in A routing

CodePudding user response:

IP routr -static 192.168.0.0 255.255.255.0 172.20.10.8

CodePudding user response:

Address translation

CodePudding user response:

Modify different IP to look at

CodePudding user response:

Superior routing routing no access to the lower, the routing access higher levels routing no problem, if the superior to access at a lower level, need to do port mapping