Want to know why I start to burn the program of a flowing water light, it can be bright, and then burn the program of a digital tube, digital tube and then is not able to show can hurt bright may program Numbers, the result of the water was bright or not this is... oh, there is no matter I am burn water lamp or the application of digital tube, digital tube will flash, then water lights have no reaction at all

CodePudding user response:

First of all, you have to control schematic diagram, check the development version of the jumper cap is correct, if the program is to provide the general manufacturers can be run, the problem is slowly analysis according to the phenomenon, a layer, don't try so hard, especially studying the matter itself, single chip microcomputer is also, even if your lights lit, phenomenon is the result of what you want to also can't prove that you have learned,

CodePudding user response:

If you have a problem code logic?

CodePudding user response:

Did you put the wrong port,

CodePudding user response:

Use of single-chip microcomputer in each pin all need initialization,
You describe is two different project, a just running water light, a digital tube, their initialization may not be compatible, check the main function of the while loop initialization part of the front!

CodePudding user response:

There should be no burn well

CodePudding user response:

New HEX code has a problem, no production